What should be paid attention to when installing attic shelves

We all know that attic shelves need a lot of effort in the installation process because of many parts and complex structure. So what should we pay attention to when installing attic shelves? Let's introduce this knowledge to you.

1. Lighting. The lighting is an essential equipment for the attic shelf. In the installation, the position of the lighting can be adjusted well, and the lighting corner can not be left in the attic. If the location of the lamp can not go through the attic shelf, it is necessary for the installation personnel to manually adjust the position of the lamp. For lighting installation, it is necessary to install all shelves after the installation of attic shelves is completed.

2. Stairs. In order to facilitate the installation of attic shelves, installing attic stairs first can reduce the installation time. It is recommended that movable stairs can be installed first. If the stairs are welded and fixed, they can only be installed after the installation of attic shelves, so as to avoid the deviation of passage distance and the failure of normal installation of stairs.

3. Laminate shelves in the attic. Attic shelves will not exist alone. Usually, in the storage environment, the upper layer of attic shelves will be equipped with laminate shelves. The installation of laminate shelves can only be installed after the attic laying and welding are completed.

4. Structural positioning. During structural positioning, blank space shall be reserved according to the actual situation. Similar to the through shelf, install the column first, and then graft the beam. Or alternatively, one column and one beam.

5. Chemical bolt stability. After the installation of column beam, chemical bolts shall be used for drilling immediately. Wait about 10 minutes after chemical bolt drilling before installing parts of attic shelf.

6. Planking installation. The installation of planking is relatively easy. After installation, multi-point welding is required to ensure that the laminate will not make friction or moving sound after being extruded. Therefore, the installation personnel need to continuously debug during installation.

7. Installation of parts on the ground floor of the attic. The installation of parts at the bottom of the attic is usually carried out after the overall structure of the attic is completed, and it can also be adjusted by itself.